A good gravel road sheds water. Most problems, such as potholes, washboard and soft spots, start when it can’t.
- Grade when the surface is damp, after a rain, so the gravel moves and packs.
- Pull material back from the edges into the center. Gravel migrates to the shoulders with traffic.
- Shape the crown. Many road guides recommend about 4%, roughly half an inch per foot, from the center to each edge.
- Cut below the bottom of potholes and washboard rather than skimming the top, then reshape.
- Keep ditches open so water leaves the road. A rear steer grader reaches the ditch without driving in it.
Use blade tilt (up to 15 degrees on HyGrade graders) to set the crown slope, and angle the blade so material rolls toward the center. Most HyGrade models from the 10 ft HD up come with a blade tilt indicator, so you can repeat the same setting pass after pass. For the full method, see the Federal Highway Administration’s Gravel Roads Construction and Maintenance Guide.
Grader for roads: compare models · buying guide
